Iron-on instructions
Step 1:
Clean the area you want to iron on! Use a damp cloth and then dry the surfaces (this application is not necessary for fabrics)
Step 2:
Turn on your iron and set it to around 130-150°C, turning off the steam.
Step 3:
Carefully remove the back protective film and position the stickers on your desired surfaces.
Step 5:
Before removing, press over all areas again to make sure the sticker is fully adhered. Once everything is firmly stuck and the stickers have cooled, carefully peel off the plastic cover. If it doesn't fit tightly or there are creases, you can place a piece of baking paper/parchment paper over the stickers and lightly iron it again.
Clean the area you want to iron on! Use a damp cloth and then dry the surfaces (this application is not necessary for fabrics)
Turn on your iron and set it to around 130-150°C, turning off the steam.
Carefully remove the back protective film and position the stickers on your desired surfaces.
Step 4:
Use the tip of the iron to apply heat and pressure to the decal for about 10-20 seconds. Do not remove the plastic immediately afterwards as the sticker needs to cool down first.
Before removing, press over all areas again to make sure the sticker is fully adhered. Once everything is firmly stuck and the stickers have cooled, carefully peel off the plastic cover. If it doesn't fit tightly or there are creases, you can place a piece of baking paper/parchment paper over the stickers and lightly iron it again.
Tip: If you want to apply the stickers to a sneaker, we recommend avoiding places where there are creases as the stickers can wear off. Flat areas of the shoe are best suited for best, long-lasting results.